Car problems · Hobart & Glenorchy

Check engine light on?

The check engine light is your car's way of saying the engine computer has seen a reading it doesn't like. It doesn't tell you what, and it doesn't always mean a big bill. The only way to know is to read the fault codes, which is what we do at our Glenorchy workshop.

Steady light: drive gently and book in. Flashing light: stop.
Not sure? Call us before you drive it.

What are the likely causes?

A loose or worn fuel cap

The fuel system is sealed. A cap that isn't clicked on properly lets vapour escape and can set the light. Check it first; it costs nothing.

An oxygen sensor

These sensors measure the exhaust so the computer can adjust the fuel mixture. They wear out with age and kilometres and are among the most common triggers.

Spark plugs or ignition coils

A worn plug or failing coil causes a misfire. You may feel the engine shake at idle or stumble under load.

An airflow or vacuum problem

A dirty airflow meter or a split hose lets the engine run lean, which the computer notices quickly.

The catalytic converter

Usually the result of another fault left too long, such as a misfire sending unburnt fuel into the exhaust.

Is it safe to keep driving?

If the light is steady and the car feels normal, it is generally fine to drive carefully for a short time, but book it in within days, not months. If the light is flashing, the engine is misfiring badly enough to damage the catalytic converter: slow down, pull over when safe and call us. Also stop if the light comes with overheating, an oil pressure warning, loud knocking or a serious loss of power.

What do we check?

We connect a professional scan tool and read every module, not only the engine: ABS, airbag, transmission and body systems too. We look at the stored codes, the freeze-frame data that shows what the car was doing when the fault occurred, and live sensor readings with the engine running. You get a printed or digital report and a plain-English explanation of what it means and how urgent it is.

Prevention & what to tell us

Before you come in, note whether the light is steady or flashing, when it first appeared and whether anything else changed at the same time, such as a fill-up at a different service station, rough running or higher fuel use. Don't disconnect the battery to clear the light; that wipes the stored freeze-frame data we use to find the fault, and the light will usually return. Regular servicing helps prevent many of the common triggers, because spark plugs, filters and fluids are checked before they cause trouble.

Which of our services fixes it?

The starting point is our Full Computer Diagnostic Scan & Report for $140. It covers fault code reading, a live-data health check and the report. If the cause needs further physical fault-tracing, wiring repairs or component testing beyond the initial scan, that is quoted separately at our standard workshop labour rate of $120 an hour. Where the cure is worn spark plugs or a tired engine, we quote the repair for your vehicle before doing anything.

Where to find us

46 Grove Rd, Glenorchy TAS 7010

About ten minutes north of Hobart via the Brooker Highway, with free parking on site. We see drivers from Glenorchy, the northern suburbs and greater Hobart, and every repair is quoted before work starts.

Getting here from Hobart

Get it looked at properly

Tassie Automotive, 46 Grove Rd, Glenorchy TAS 7010. Open Mon–Fri 8am–5pm, Sat 9am–5pm, Sun 10am–5pm.

Book nowCall now

Get the Tassie Automotive app

Install it on your phone — book services in one tap.